Product Description
The Hobart AirForce 500i plasma cutter is an economical plasma cutter system for all conductive metals. Inverter-based design and reliable technology pack a lot of performance into a very portable package. The AirForce 500i features a multi-voltage plug MVP that allows user to connect to common 120V or 230V power receptacles. Plasma cutters cut faster and more precise with a thinner kerf and less slag than cutting with oxy fuel. A smaller heat-affected zone also causes less warping. And you’ll never have gas pressure settings, flame tuning, metal preheating, or gas cylinders or refills to worry about. Cart No, Dimensions L x W x H in. 14 1/4 x 8 1/4 x 11 1/4, Volts 115/230, Clamp Cable Length ft. 16.5, Duty Cycle 35 @ 27 Amps, Cutting Thickness in. Up to 5/8, Plasma Gas Flow/Pressure 4.5 CFM at 60 PSI, Power Cord ft. 10, Amps 27, Pilot Arc Yes. Inverter design gives you powerful cutting ability at half the weight of prior models Complete cutting capability when powered by an engine-driven welder or generator with a 240V generator power outlet of 6 KW or more Ergonomic HP-50 torch is designed for increased comfort, more efficient cooling, economical replacement cutting tips and easier to deal with than oxy fuel cylinders Post-flow air cooling cools the torch and tip after cutting, extending life of replaceable tip and electrode Fan on-demand runs only when needed, reducing dust/debris pulled into unit Wind tunnel technology prevents abrasive dust particles from damaging internal components Thermal overload protection withstands tough work environments Cable management strap secures torch, work cable and power cord for easy transport Line Voltage Compensation provides peak performance power under variable input voltage conditions 15 for steady and cleaner ending cuts Power factor correction expands operator’s work area via extension cords while minimizing trips caused by voltage drops Hobart 5/3/1 limited warranty
Inverter-based design and reliable technology pack a lot of performance into a very portable package.
An economical plasma cutting system for all conductive metals.
This power source adapts to your work site by operating from either 115 or 230 VAC power through standard household outlet using the Multi-Voltage Plug (MVP).
Frequently Bought Together
-
This item: Hobart 500548 Airforce 500i 115/230 Volt Plasma Cutter$1.00
-
$18.69
-
$19.99
-
$71.19
Reviews
There are no reviews yet.