The DELTA 15-262 6 Speed Drill Press features a 3/4 HP single-phase motor that has a 24-volt push-button, magnetic starter. It provides six speeds varying from 425 to 5500 RPM, and is able to all drill jobs on different materials. The drill maintains proper belt tension robotically so you’ll be able to at all times have full power transmission. A snubber feature holds speed settings constant no matter the load conditions. The quill is large with a two-inch diameter, and a long quill go back and forth means that you can do deep-hole jobs such as skip and gang drilling. The drill features extra-large spindle bearings “6 PLUS 6” and “VS6” spindle and spindle pulleys that are supported by lubricated-for-life ball bearings. The production table tilts 90 degrees in both directions and measures 15.5 x 21.5 inches (12 x 18 inches inside of coolant trough). Included is the table, motor and controls, belt and pulley guard, belt and motor pulley, self-locking depth stop, depth gauge, self-ejecting chuck key.
Extra-large spindle bearings 6 PLUS 6 and VS6 spindle and spindle pulley are supported by four over-sized, pre-loaded, lubricated-for-life ball bearings.
Wide, test-proven speed range provides you with a true 10-to-1 speed ratio. You get the exact speed you want for each drilling job on any material- 450-4,700 rpm with a 1,725 rpm motor.
Quick belt tension release is provided by the pivoting motor mounting plate which has a reverse, self-locking taper at the spring-loaded, rubber-tipped plunger that quickly restores correct belt tension
Extra-long quill go back and forth gives the extra depth you want for deep-hole jobs like skip and gang drilling.
Six speeds offer unbelievably wide range of speeds with a low-cost 1,725 rpm motor- 425; 600; 1,100; 2,050; 3,900 and 5,500 rpm- 11.8 to 1 speed ratio.