PP12005: 120 GPH, Submersible, Hydroponics/Fountain/Pond/Statuary/Aquarium Pump – 5′ Cord

PP12005-120-GPH-Submersible-HydroponicsFountainPondStatuaryAquarium-Pump-5-Cord-0
PP12005-120-GPH-Submersible-HydroponicsFountainPondStatuaryAquarium-Pump-5-Cord-0
PP12005-120-GPH-Submersible-HydroponicsFountainPondStatuaryAquarium-Pump-5-Cord-0-0
PP12005-120-GPH-Submersible-HydroponicsFountainPondStatuaryAquarium-Pump-5-Cord-0-1
PP12005-120-GPH-Submersible-HydroponicsFountainPondStatuaryAquarium-Pump-5-Cord-0-2
PP12005-120-GPH-Submersible-HydroponicsFountainPondStatuaryAquarium-Pump-5-Cord-0-3
 
Sale!
 

$29.99 $13.99 (as of June 19, 2014, 10:10 pm)

COMPLETE SELECTION: We have 7 sizes & 13 models. Click on “PonicsFarm” near the top of the page to see them all. This model has a high quality 5 foot waterproof cord. Comes with adjustable input flow-rate screen and 2 outlet adaptors for 1/4″ & 1/2″ inside diameter tubing.
DURABLE QUALITY: Our Polished Stainless Steel #205 Impeller Shaft insures long pump life. Epoxy Resin Encasement of key internal motor components prevents unwanted conductivity and corrosion of metal parts. This pump incorporates a magnetic wet-rotor design, so there is no seal to fail that would damage the pump motor.
EFFICIENT: Neodymium Iron Boron (NdFeB) Magnets are used in all our electric motors because they are the most powerful permanent magnetic materials commercially available and increase energy efficiency. Water-Lubricated Nitrile Bushings are used because they possess a very low coefficient of friction, have inherent vibration-dampening qualities and are non-polluting.

Qty

Product Description

HOW TO CHOOSE A HYDROPONIC, AQUAPONIC, ALGAPONIC, AQUARIUM, POND OR FOUNTAIN PUMP

First remember:
 – “Maximum Flow Rate” is meaningless because it is at ZERO lift.
 – “Maximum Head/Lift” is meaningless because the flow at that height is only a trickle.

You need to choose an affordable quality pump that produces the “desired flow at your required lift” at the lowest wattage.

Step 1: Determining Desired Flow Rate
Hydroponic Systems – typically flow through a single loop allowing a single pump and need a flow rate near 100 GPH for each grow bed loop up to 120 feet. Flood/drain beds – need 2 to 4 cycles per hour. Fish tanks – need a least one exchange per hour or extra oxygenation. Waterfalls – need 100 GPH for each inch of width.

Step 2: Calculating System Lift
Measure the “vertical distance” from the “top” of the water in the pump tank to the pump discharge point.

Step 3: Pump Selection Considerations
 – Continuous instead of intermittent pump duty cycle greatly increases pump life, plus no need for a timer or level control.<br  – Low cost (<$60) pumps in the 3 to 60 watt pump range are typically submersible.
 – A rule of thumb is that an average pump will last 2-4 times the stated warranty period.
 – Best to buy a backup pump if fish or plants depend on the pump.

Note: A foam filter is rarely needed, a screen cover is enough.

DO NOT USE WITH SOLAR POWER! Voltage often fluctuates below requirements.
COMPLETE SELECTION: We have 7 sizes & 13 models. Click on “PonicsFarm” near the top of the page to see them all. This model has a high quality 5 foot waterproof cord. Comes with adjustable input flow-rate screen and 2 outlet adaptors for 1/4″ & 1/2″ inside diameter tubing.
DURABLE QUALITY: Our Polished Stainless Steel #205 Impeller Shaft insures long pump life. Epoxy Resin Encasement of key internal motor components prevents unwanted conductivity and corrosion of metal parts. This pump incorporates a magnetic wet-rotor design, so there is no seal to fail that would damage the pump motor.
EFFICIENT: Neodymium Iron Boron (NdFeB) Magnets are used in all our electric motors because they are the most powerful permanent magnetic materials commercially available and increase energy efficiency. Water-Lubricated Nitrile Bushings are used because they possess a very low coefficient of friction, have inherent vibration-dampening qualities and are non-polluting.
SAFE & EASY: Safe for fish with no exposed copper and oil free. Easy to clean with no tools required to disassemble and clean filter/impeller. Our SJTW Electric Cord is waterproof, 18# gauge copper wire, molded plug with ground, heavy duty flexible vinyl jacket, resists oil/grease/moisture, abrasion resistant and very good flexibility at all temperatures.
SPECIFICATIONS: Fresh water only with flow Rates of 119 Gallons Per Hour (GPH) @ 0′ Lift; 95 GPH @ 1′ Lift; 66 GPH @ 2′ Lift; 20 GPH @ 3′ Lift; Max Lift – 3′ 1″. Dimensions are 2.56″ x 1.65″ x 1.95″. 120VAC, 6 WATTS. 1 year limited warranty when sold by PonicsFarms.

Frequently Bought Together

  • PP12005: 120 GPH, Submersible, Hydroponics/Fountain/Pond/Statuary/Aquarium Pump - 5' Cord
    +
  • Watts SVIG10 Pre-Cut 1/2-Inch Diameter by 3/8-Inch Clear Vinyl Tubing, 10-Foot Length
    +
  • FHS4: Water Fountain Spray Heads/Nozzles for Pond - Set of 4
    +
  • PP21105 : 211 GPH, Submersible, Hydroponics, Aquaponics, Aquarium Pump - 12W
  • Price for all: $46.03

Additional Information

Brand

PonicsPumps

CatalogNumberList

PP12005

Color

Black

EAN

0609456180962

EAN List

0609456180962

Label

PonicsFarm

Manufacturer

PonicsFarm

Model

PP12005

MPN

X0009TVG1Z

PackageDimensions

140, hundredths-inches, 410, hundredths-inches, 2, hundredths-pounds, 280, hundredths-inches

Package Quantity
Part Number

X0009TVG1Z

Product Group
ProductTypeName

OUTDOOR_LIVING

Publisher

PonicsFarm

Size

120 GPH, 6W

Studio

PonicsFarm

UPC

609456180962

UPC List

609456180962

Warranty

1 year

Category: